The Archer - Raw - 3DP Design Prototype

MOI: 5800 g-cm^2
Face material: Steel
Headweight: 364 grams
Loft: 3°; Lie: 71°
Offset: 1/2 shaft
Toe-Hang: 4:30
Materials: 420 stainless steel/bronze, tungsten, aluminum
Surface texture: As printed (rough)
Finish: Raw
   Steel/Bronze body: 3D printed with Binder Jet technology
   Steel face and cavity inserts: photochemically milled

This 3D-printed putter is fully assembled and ready to grip and ship.

A Thin Blade With Thick MOI

This prototype 3DP version of the Archer borrows the curved topline and easy alignment of the milled version of the Archer, but shaves off the rear flange to radically slim down the putter's appearance at address.  As a result this prototype is thinner than a typical heel-toe weighted blade and is more reminiscent of skinny blades from the 1990s that fell out of fashion as the putter industry focused increasingly on high-MOI mallets.

But as you can see from the exposed tungsten weights in the heel and toe, this putter is no slouch in the MOI department.  This putter contains a full 112g of tungsten - 31% of its total headweight of 364g -- yielding an MOI of 5800!

This prototype has been left raw with no plating and it will rust and develop a darker brown patina over time.  

Related Items

Would you like to join our email list to be notified of new product release and exclusive promotions?